R&S FPC Series - Page 385

Function Reference
R&S
®
FPC
382User Manual 1178.4130.02 ─ 07
CISPR BW: Auto
See "Selecting the bandwidth" on page 143.
Remote command:
[SENSe:]BANDwidth[:RESolution]:CISPr:AUTO on page 300
20.5.5 Sweep Menu
Access: [Sweep]
Measurement Time..................................................................................................... 382
Continuous Scan.........................................................................................................382
Single Scan.................................................................................................................382
Measurement Time
See "Defining the measurement time" on page 144.
Remote command:
[SENSe:]SWEep:TIME on page 261
Continuous Scan
See "Selecting the measurement mode" on page 144.
Remote command:
Scan mode: INITiate:CONTinuous on page 262
Start scan: INITiate[:IMMediate] on page 263
Single Scan
See "Selecting the measurement mode" on page 144.
Remote command:
Scan mode: INITiate:CONTinuous on page 262
Start scan: INITiate[:IMMediate] on page 263
20.5.6 Trace Menu
Access: [Trace]
Select Trace................................................................................................................ 382
Trace Mode................................................................................................................. 383
Detector.......................................................................................................................383
Memory....................................................................................................................... 383
Trace ▶ Memory......................................................................................................... 383
Trace Style: Lines........................................................................................................383
Trace Style: Polygon................................................................................................... 383
Select Trace
See "Selecting a trace" on page 114 and "Selecting a second trace" on page 114.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>[:STATe] on page 268
Function Reference: Receiver Application