R&S FPC Series - Page 386

Function Reference
R&S
®
FPC
383User Manual 1178.4130.02 ─ 07
Trace Mode
See "Selecting the trace mode" on page 116.
(Supported trace modes: clear / Write, max hold, min hold and average.)
Remote command:
Trace mode: DISPlay<n>[:WINDow]:TRACe<t>:MODE on page 267
# of averages: [SENSe:]SWEep:COUNt on page 270
Detector
See Chapter 15.6, "Trace Configuration", on page 144.
(Supported detectors: max peak, quasi peak, average and RMS.)
Remote command:
Detector: [SENSe:]DETector<t>[:FUNCtion] on page 300
Memory
See "Working with memory traces" on page 117.
Remote command:
CALCulate<n>:MATH<t>:COPY:MEMory on page 266
Trace ▶ Memory
See "Working with memory traces" on page 117.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:MEMory[:STATe] on page 267
Trace Style: Lines
See "Selecting the trace style" on page 137.
Remote command:
DISPlay[:WINDow]:TRACe:STYLe on page 301
Trace Style: Polygon
See "Selecting the trace style" on page 137.
Remote command:
DISPlay[:WINDow]:TRACe:STYLe on page 301
20.5.7 Lines Menu
Access: [Lines]
Show Limit Lines.........................................................................................................383
Upper Limit..................................................................................................................384
Lower Limit..................................................................................................................384
Select Trace <x>......................................................................................................... 384
Audio Beep..................................................................................................................384
Show Limit Lines
See "Hiding a limit line" on page 132.
Function Reference: Receiver Application