R&S FPC Series - Page 383

Function Reference
R&S
®
FPC
380User Manual 1178.4130.02 ─ 07
Log Scale
See "Selecting the scale of the x-axis" on page 141.
Remote command:
[SENSe:]SWEep:SPACing on page 298
20.5.3 Amplitude Menu
Access: [Ampt]
Reference Level..........................................................................................................380
Range / Ref Position................................................................................................... 380
Auto Range................................................................................................................. 380
Unit..............................................................................................................................381
Preamplifier.................................................................................................................381
Attenuator....................................................................................................................381
Impedance.................................................................................................................. 381
Transducer.................................................................................................................. 381
Reference Level
See "Defining a reference level" on page 99.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel on page 253
Range / Ref Position
Bargraph:
●
"Defining the bargraph scale" on page 142
Frequency scan:
●
"Defining a display range" on page 104
●
"Defining the position of the reference level" on page 100
●
"Defining a reference offset" on page 100
Remote command:
Scale (y-axis): DISPlay<n>[:WINDow]:TRACe<t>:Y:SPACing on page 252
Range (y-axis): DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe] on page 252
Range (automatic): DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust
on page 253
Reference position: DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RPOSition
on page 254
Reference offset: DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:RLEVel:
OFFSet on page 254
Auto Range
Bargraph: "Defining the bargraph scale" on page 142
Frequency scan: "Defining a display range" on page 104.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust on page 253
Function Reference: Receiver Application