R&S FPC Series - Page 382

Function Reference
R&S
®
FPC
379User Manual 1178.4130.02 ─ 07
Frequency
See "Defining the receiver frequency" on page 139.
(Bargraph measurements only.)
Remote command:
[SENSe:]FREQuency:CENTer on page 297
Frequency Step
See "Defining a frequency step size" on page 139.
(Bargraph measurements only.)
Remote command:
[SENSe:]FREQuency:CENTer:STEP on page 248
Scan Step
See "Defining a scan range" on page 140.
(Frequency scans only.)
Remote command:
[SENSe:]SCAN:STEP on page 297
Start Frequency
See "Defining a scan range" on page 140.
Remote command:
[SENSe:]SCAN:STARt on page 297
Stop Frequency
See "Defining a scan range" on page 140.
Remote command:
[SENSe:]SCAN:STOP on page 298
Full Scan
See "Defining a scan range" on page 140.
Remote command:
not supported
Frequency Mode
See "Using channel tables" on page 139 and "Performing a channel scan"
on page 140.
Remote command:
Mode: [SENSe:]FREQuency:INPut:MODE on page 249
Channel selection: [SENSe:]CHANnel on page 246
Linear Scale
See "Selecting the scale of the x-axis" on page 141.
Remote command:
[SENSe:]SWEep:SPACing on page 298
Function Reference: Receiver Application