R&S FPC Series - Page 403

Function Reference
R&S
®
FPC
400User Manual 1178.4130.02 ─ 07
Range (return loss): DISPlay<n>:MAGNitude:Y:SCALe on page 331
Range (phase): DISPlay<n>:PHASe:Y:SCALe on page 333
Range (SWR): DISPlay<n>:VSWR:Y:SCALe on page 334
Range (SWR): DISPlay<n>:VSWR:Y:SCALe:MINimum on page 335
Range (SWR): DISPlay<n>:VSWR:Y:SCALe:MAXimum on page 334
Y-axis scale (return loss): DISPlay<n>:MAGNitude:Y:SPACing on page 331
Auto Range
See "Defining the display range" on page 182.
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:Y[:SCALe]:ADJust on page 253
Full Scale
See "Defining the display range" on page 182.
Remote command:
not supported
20.8.5 Bandwidth Menu
Access: [BW]
RBW: Manual..............................................................................................................400
RBW: Auto...................................................................................................................400
RBW: Manual
See "Defining the measurement bandwidth" on page 182.
Remote command:
[SENSe:]BANDwidth[:RESolution] on page 259
RBW: Auto
See "Defining the measurement bandwidth" on page 182.
Remote command:
[SENSe:]BANDwidth[:RESolution]:AUTO on page 260
20.8.6 Sweep Menu
Access: [Sweep]
Continuous Sweep......................................................................................................400
Single Sweep.............................................................................................................. 401
Hold.............................................................................................................................401
Number of Points........................................................................................................ 401
Continuous Sweep
See "Selecting the measurement mode" on page 183.
Function Reference: Vector Network Analyzer