R&S FPC Series - Page 404

Function Reference
R&S
®
FPC
401User Manual 1178.4130.02 ─ 07
Remote command:
Sweep mode: INITiate:CONTinuous on page 262
Start sweep: INITiate[:IMMediate] on page 263
Single Sweep
See "Selecting the measurement mode" on page 183.
Remote command:
Sweep mode: INITiate:CONTinuous on page 262
Start sweep: INITiate[:IMMediate] on page 263
Hold
See "Selecting the measurement mode" on page 183.
Remote command:
not supported
Number of Points
See "Defining the number of measurement points" on page 184.
Remote command:
[SENSe:]SWEep:POINts on page 337
20.8.7 Trace Menu
Access: [Trace]
Trace Mode................................................................................................................. 401
Memory....................................................................................................................... 401
Trace ▶ Memory......................................................................................................... 401
Trace Math.................................................................................................................. 402
Trace Mode
See "Selecting the trace mode" on page 116.
Remote command:
Trace mode: DISPlay<n>[:WINDow]:TRACe<t>:MODE on page 267
# of averages: [SENSe:]SWEep:COUNt on page 270
Memory
See "Working with memory traces" on page 117.
(Only one trace available in VNA.)
Remote command:
CALCulate<n>:MATH<t>:COPY:MEMory on page 266
Trace ▶ Memory
See "Working with memory traces" on page 117.
(Only one trace available in VNA.)
Remote command:
DISPlay<n>[:WINDow]:TRACe<t>:MEMory[:STATe] on page 267
Function Reference: Vector Network Analyzer