© REA Elektronik GmbH REA ScanCheck 3 - August 2010
Page
17 of 89
D-64367 Mühltal-Waschenbach
+49 (0) 6154-638 0 www.rea-verifier.de
REA
Automation
Electronic Devices and Systems
3.3 Operating REA ScanCheck 3n with Report Printer
The REA ScanCheck 3n verification unit can also be operated together with the portable report printer
type REA TD-GPT-U.
The printer is first connected with the supplied connection cable via the Mini USB plug and then with
the Type A USB plug to the USB socket to the lower face of the REA ScanCheck 3.
The printer has its own power supply via an installed battery.
This must be completely charged before use with the supplied printer power supply.
(see also operating manual for the portable printer REA TD-GPT-U).
A compact plug charger for charging the internal battery with 6 volts of output voltage is supplied with
the printer. Interchanging the plug power supply for the REA ScanCheck 3n is not possible. The
specifications in the REA TD-GPT-U operating manual must be observed for all other operating
instructions for the report printer.
Operation with other printers is not possible and not intended.
The predecessor model REA ScanCheck 3, which could be connected to a PC via USB, was supplied with a 9V
power supply. The printer power supply and the ScanCheck 3 power supply could be interchanged in this
configuration.
To Next Page
Loading...
Need help?
General
