Automation
Electronic Devices and Systems
With the Continue command, the next page for the configuration of the report contents for multiple
measurements can be called up. The left column shows the number of the respective multiple measurement,
from 1 to 10.
The print-out of the ISO/IEC 15416 parameter can be activated or
deactivated in the ISO/ANSI
column for each individual measurement.
The same can be specified for the print-out of the optional parameters
(Opt. P.), for the detailed
evaluation (Details) and for the scan reflection profile (SRP).
The settings in the example shown would lead to a very long print-out, because all information on the ISO and
optional parameters would be output for each of the 10 individual measurements. Only the output of the detailed
evaluation was selected only for the 3rd individual measurement.
If a print command is triggered with the <Print S> button in the case of a multiple measurement, by way of
contrast, solely a summary of the results as a table with the total class and the scan reflection profile classes of
the individual measurements would be listed on the report print-out with the ISO/IEC 15416 parameters. This
compact print-out would be repeated 10 times upon requesting a print-out with the <Print L> command (insofar
as a 10x multiple measurement was made).
4.6.3.5 Setup Menu 3 Settings - 5 Code Comparator (Option Only)
Is an optional expansion of the standard software package. With the "Code Comparator"
function, the code content of a code to be verified can be compared with the code
content information entered here. Only the code content is compared, not the code symbology.
Operation with the REA ScanCheck 3 can be enabled with a license key.
The respective function can be activated by filling in the box.
On means that the function is incorporated in the code evaluation. That is, if the code content of a
measured code is not identical with the preset code contents, this is evaluated as an error.
Anz. (Disp.) means that the result of the comparison is displayed but is not incorporated into the
evaluation.
Off means that the comparator function is completely deactivated.
For input of the code content that is to be compared with the code content to be measured,
1. the last scanned code content can be taken over into the lower field. To do so, select the "load
current code content" field and then press the <OK ENTER> button. The last code content saved
internally is thereby written to the data field.
2. an individual code content can be entered with the keyboard in the lower field.
To do so, activate the input field with the arrow buttons until it is highlighted in red.
Existing characters can be deleted to the left with the <del.> button.
Numbers, letters and special characters can be entered by pressing the number buttons multiple times
(similar to a cell phone keyboard for text messaging).
The inputs are accepted by pressing the <OK> button. Pressing the <Back> button discards and
does not accept the changes made on this menu page.
4.6.3.6 Setup Menu 3 Settings - 6 Article Search (Option Only)
Article Search: is an optional expansion of the standard
software package. With the
"Article Search" function, the code content of the code to be verified can be compared with
all code content information stored in an article database.
Only the code content is compared, however, not the code symbology - which may differ.
To Next Page
Loading...
Need help?
General
