Automation
Electronic Devices and Systems
8. Intellectual Property Provision
This document and the information and specifications contained in this document are property of
REA Elektronik GmbH. It includes step-by-step instructions with which one can quickly learn to handle
the product described and serves for support in commissioning and operating a product manufactured
by REA Elektronik GmbH.
This documentation as a whole and parts thereof are copyrighted.
All rights, including that of translation, reprinting and reproduction of the whole work or parts thereof,
are reserved. No parts of this work may be reproduced in any form (photocopy, microfilm or any other
process) without the previous written approval of REA GmbH, including for purposes of lesson design.
Although this documentation was created with the greatest care, some information may be incomplete
and may contain errors. REA Elektronik accepts no responsibility for damage that could occur due to
these incorrect specifications. REA Elektronik continually strives to improve its products and reserves
the right to change the specifications and data contained in this document without previous notice. The
most up-to-date version is available for download on the Internet in the Support area on the following
page. The required access information is: http://support.rea-verifier.de
Username:
"REA_Verifier“, Password: "REA-C36754“.
Protected Trademarks
All of the product names that are known to REA to be protected were correspondingly marked with the
following symbol in this document.
Microsoft®, Embedded Visual Tools®, are registered trademarks of the Microsoft Corporation in the
USA and other countries; Intel® and ARM are trademarks of the Intel Corporation. Linux is a registered
trademark of Linus Thorvalds.
REA is not responsible for the validity of this information. The use of any protected terms or names
shall not represent an injury to copyright or a protected brand.
9. Environmental Protection
As is the case with any device for electronic data capturing, the special regulations of the respective
country of use must be observed for usage and disposal.
In the scope of the European Union EU, the units must be brought for professional recycling after
expiration of use. Alternatively, the manufacturer will undertake disposal at cost.
Disposal via public utilities is not permitted in the case of commercially used units, or only permitted at
cost.
© 2010 REA Elektronik GmbH, Mühltal
Internet: http://www.rea-verifier.de Printed in Germany
To Next Page
Loading...
Need help?
General
