RFL 9660 RFL Electronics Inc.
April 24, 2007 13-20 (973) 334-3100
0 Disable automode
1 Enable automode (default)
max_rate An optional number that specifies the highest rate at which the modem may establish an upstream
(transmit) connection. The value is decimal coded in units of bps, for example, 33600 specifies the
highest rate to be 33600 bps.
0 Maximum rate determined by the modulation selected in mod (default).
300–33600 Maximum rate value limited by the modulation selected in mod. For valid max_rate values for each mod
value, see the following table.
mod value Valid max_rate values (bps)
V92, V90, V34 31200, 28800, 26400, 24000, 21600,19200, 16800,
14400, 12000, 9600, 7200, 4800, 2400
V32B 19200, 16800, 14400, 12000, 9600, 7200, 4800
V32 14400, 12000, 9600, 7200, 4800
V22B 2400
V22, V23C, Bell212A 1200
V21, Bell103 300
max_rx_rate An optional number that specifies the highest rate at which the modem may establish a downstream
(receive) connection. The value is decimal coded in units of bps, e.g., 28800 specifies the highest rate to
be 28800 bps.
0 Maximum rate determined by the modulation selected in mod (default).
300–56000 Maximum rate value limited by the modulation selected in mod. See “Possible rates” in the mod table.
Command: +PCW=n Call Waiting Enable
Values:
n = 0, 1, or 2
Default:
2
Description:
Controls the action to be taken upon detection of a call waiting tone in V.92
mode. Values specified by this command are not modified when an AT&F
command is issued.
+PCW=0 Toggles V.24 Circuit 125 and collects Caller ID if enabled by
+VCID
+PCW=1 Hangs up
+PCW=2 Ignores V.92 call waiting
+PCW=? Displays the allowed values
+PCW? Displays the current value
Command: +PIG=n PCM Upstream Ignore
Values:
n = 0 or 1
Default:
1
Description:
Controls the use of PCM upstream during V.92 operation. PCM upstream
allows faster upload speeds to a V.92 server.
+PIG=0 Disables PCM upstream
+PIG=1 Enables PCM upstream
+PIG=? Displays the allowed values
+PIG? Displays the current value
To Next Page
Loading...