RFL Electronics RFL 9660 - Page 174

RFL 9660 RFL Electronics Inc.
April 24, 2007 13-21 (973) 334-3100
Command: +PMH=n Modem on Hold Enable
Values: n = 0 or 1
Default: 1
Description:
Controls if modem on hold procedures are enabled during V.92 operation.
Normally controlled by a modem on hold program. Values specified by this
command are not modified when an AT&F command is issued.
+PMH=0 Enables V.92 modem on hold
+PMH=1 Disables V.92 modem on hold
+PMH=? Displays the allowed values
+PMH? Displays the current value
Command: +PMHF V.92 Modem Hook Flash
Values:
N/A
Default:
N/A
Description:
Causes the DCE to go on-hook for a specified period of time, and then return
off-hook for at least a specified period of time. The specified period of time is
normally one-half second, but may be governed by national regulations.
“ERROR” is returned if MOH is not enabled.
Command: +PMHR=n Modem on Hold Initiate
Values:
n = 0–13
Default:
0
Description:
+PMHR is an action command that causes the modem to initiate MOH with
the central site modem. It returns the following values to indicate what has
been negotiated. Valid only if MOH is enabled and the modem is off-hook or
in data mode. Otherwise, ERROR will be returned.
+PMHR=0 Deny MOH request
+PMHR=1 Grant MOH request with 10 second timeout
+PMHR=2 Grant MOH request with 20 second timeout
+PMHR=3 Grant MOH request with 30 second timeout
+PMHR=4 Grant MOH request with 40 second timeout
+PMHR=5 Grant MOH request with 1 minute timeout
+PMHR=6 Grant MOH request with 2 minute timeout
+PMHR=7 Grant MOH request with 3 minute timeout
+PMHR=8 Grant MOH request with 4 minute timeout
+PMHR=9 Grant MOH request with 6 minute timeout
+PMHR=10 Grant MOH request with 8 minute timeout
+PMHR=11 Grant MOH request with 12 minute timeout
+PMHR=12 Grant MOH request with 16 minute timeout
+PMHR=13 Grant MOH request with indefinite timeout
+PMHR=? Displays the allowed values
+PMHR? Displays the current value