26 January, 2001 PHOTOCONDUCTOR UNIT (PCU)
3-27
Replacement
Adjustment
3.11.2 DRUM
1. PCU (☛ 3.11.1)
2. Toner cap [A]
3. Insert cap [A] into the toner entrance hole [B].
4. Make sure that the cap is inserted completely into the hole.
5. Turn the PCU upside-down, and remove lower PCU cover [C] (! x2, 3 pawls).
6. Pull the drum [D] towards the front # (the left side in the illustration) while
releasing the charge roller [E] using the release lever $ [F], and then remove
the drum %.
CAUTION: Never touch the drum surface with bare hands.
7. After replacing the drum, perform the ID sensor initial setting using SP3-001-2.
8. Do the process initial setting procedure (SP2-805).
B004R302.WMF
B004R963.WMF
B004R304.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
