19 January, 2001 SERVICE PROGRAM MODE
5-29
Service
Tables
SP5-xxx: Mode
SP5 Mode Number Function and [Setting]
5024* mm/inch Display Selection Selects the unit of measurement.
After selection, turn the main power switch off and
on.
0: Europe/Asia 1: North America
0: mm, 1: inch
5044 Operation Panel Bit SW
DFU
5104* A3/DLT Double Count Specifies whether the counter is doubled for
A3/DLT.
0: No, 1: Yes
If
!
is selected, the total counter and the current
user code counter count up twice when A3 or
DLT paper is used.
5106* 6* ADS Level Selection Selects the image density level used in ADS
mode.
[1~7 / 4 / 1 notch per step]
Example: If you set SP5-106-6 to “2”: Pressing
the Auto Image Density key toggles the display
off and manual notch 2 is selected.
Adjust this SP if the customer cannot attain clean
copies after performing automatic density
adjustment.
5112* Non-Standard Paper
Selection
Determines whether a non-standard paper size
can be initialized for copying or not.
0: No, 1: Yes
If ! is selected, a non-standard size can be
input using the UP mode.
5113* Optional Counter Type
Selects the corresponding key for installed
devices such as a coin lock. Japan only
[0~5 / 0 / 1 step]
0 None.
1 Key card (RK3, RK4)
2 Key card (subtraction count setting)
3 Pre-paid card
4Coin lock
5MF key card
5118* Disable Copying
DFU
5120* Mode Clear Opt. Counter
Removal
Clears all coin devices. Japan only
[0~2 / 0 / 1 step]
0: Normal reset.
1: Resets only when job finished or before job
begins.
2: Not normal reset.
5121* Counter Up Timing Determines whether the optional key counter
counts up at paper feed or at paper exit.
0: Feed, 1: Exit
The total counter is not affected by this SP mode.
5127* APS Mode
Selects whether the APS function is enabled or
disabled with the contact of a pre-paid card or
coin lock.
0: Enabled, 1: Disabled
To Next Page
Loading...
