Ricoh A-C2 - 3 Replacement and Adjustment; Upper Cover

5 June, 2001 RSS SET UP
APPENDIX-1
APPENDIX 1 (FOR MODEL A-C2)
1. RSS (REMOTE SERVICE SYSTEM)
1.1 RSS SET UP
!
CAUTION
Unplug the machine power cord before starting the following procedure.
1. Remove the rear upper cover [A] (2 screws).
2. Remove the rear lower cover [B] (4 crews).
3. Remove the CSS cover [C] (1 screw).
4. Remove the bracket [D] (4 screws).
5. Install the RSS board [E] (3 screws).
6. Install the harness [F] between the RSS board and the Mother board.
When connecting only one machine to the line adapter, skips step 7.
7. Set the jumper switch [G] on the RSS board as shown (default setting is 1-2).
B004I552.WMF
B004I551.WMF
[D]
[E]
[F]
[G]
[A]
[B]
[C]