RSS SET UP 5 June, 2001
APPENDIX-2
Machine No. 1 2 3 4 5
Jumper Set 2-3 2-3 2-3 2-3 1-2
PI device
code
01234
8. Reassemble the machine.
9. Connect the modular cord [A] to the line adapter as shown.
10. Install the line adapter (refer to chapter 2-1 L-ADP Installation Procedure in the
CSS Service Manual).
11. Turn on the machine.
When connecting only one machine to the line adapter, skips step 12.
12. Enter the Copier SP mode and set the PI device code with SP5-821 (default 0).
NOTE: After changing the value, turn the main power switch off and on to
enable the PI device code.
B004I553.WMF
Line Adapter
A265I900.WMF
[A]
To Next Page
Loading...
