SERVICE PROGRAM MODE 19 January, 2001
5-6
SP1 Mode Number Function and [Setting]
1105* 8* Roller Ends: By-Pass
(Thick Paper Feed)
9*
Re-load Temp. Minus:
Roller Center (Thick
Paper)
10*
Re-load Temp. Minus:
Roller Ends (Thick Paper)
Forces paper feed to wait until the fusing unit has
reached the specified temperature.
Feed temp. = Spec. temp. for thick paper – SP
value
Feed begins when the hot roller reaches the
specified temperature.
[0
o
C ~ 60
o
C / 0
o
C (B004/B007: 5
o
C / 1
o
C step]
1106 Fusing Temperature
Display
1 Roller Center
2 Roller Ends
Displays the fusing temperature for the center or
ends of the hot roller.
This machine has two fusing lamps inside the hot
roller: one lamp heats the center of the roller, the
other lamp heats both ends.
1109* Fusing Nip Band Check
Checks the fusing nip band. (☛ 5.1.7)
[0=Off, 1=On]
1111*
Paper Reverse Timing
(Duplex)
Adjusts the timing for stopping the rotation of the
reverse roller after the trailing edge of the paper
passes the duplex entrance sensor.
[+5 ~ –5 / 0 mm / 1 mm step]
Adjust the timing if paper frequently jams at the
inverter gate in the duplex unit.
To Next Page
Loading...
