26 January, 2001 MAIN MACHINE INSTALLATION
1-9
Installation
6. Spread a large piece of paper on a flat surface.
NOTE: Make sure the area is free of pins, paper clips, staples, etc. to avoid
attraction to the magnetic development roller.
7. Slide the development unit [A] out and place it on the paper.
8. Remove the tape and tag [B] from the development unit
9. Remove the entrance seal plate [C] (" x2).
B004I512.WMF
B004I105.WMF
[A]
[B]
[C]
To Next Page
Loading...
