5 June, 2001 OTHERS
APPENDIX-7
Document Feeder
Code Meaning
03 Original does not reach the Skew Correction Sensor
04 Original does not reach the Interval Sensor
05 Original does not reach the Registration Sensor
06 Original does not reach the Relay Sensor
07 Original does not reach the Inverter Sensor
53 Original caught at the Skew Correction Sensor
54 Original caught at the Interval Sensor
55 Original caught at the Registration Sensor
56 Original caught at the Relay Sensor
57 Original caught at the Inverter Sensor
1.4.2 PAPER SIZE
Code Paper Size Code Paper Size
05 A4 sideways 86 A5 lengthwise
06 A5 sideways 87 A6 lengthwise
07 A6 sideways 8D B4
0E B5 sideways 8E B5 lengthwise
0F B6 sideways 8F B6 lengthwise
11 Return post card sideways 91 Return post card lengthwise
12 Post card sideways 92 Post card lengthwise
24 8.5
[t1]
" x 14” sideways A0 11" x 17"
26 8.5" x 11” sideways A4 8.5" x 14" lengthwise
2C 8.5" x 5.5” sideways A6 8.5" x 11" lengthwise
84 A3 AC 8.5" x 5.5" lengthwise
85 A4 lengthwise
1.5 OTHERS
1.5.1 SC630 [RDS COMMUNICATION ERROR]
Frequent occurrence of SC630 indicates a problem in the customer’s
communication line or line adapter. To maintain the communications environment
in good working order, it is necessary to contact planned inspections periodically.
1.5.2 PM PROCEDURE OR OTHER MAINTENANCE
Before beginning PM or other maintenance procedures, SP5-816-2 should be set
to "0". This will disable the RDS function. When maintenance is completed, SP5-
816-2 should be set to "1". This will re-enable the RDS function.
NOTE: The RDS function will remain disabled for four hours. Therefore, if
maintenance for longer than four hours is required, SP5-816-2 should be
set to "0" again to disable RDS.
To Previous Page
Loading...
