Ricoh A-C2 - Page 36

26 January, 2001 PAPER TRAY UNIT INSTALLATION
1-19
Installation
3. Remove the middle front cover [A], and pull out the front handles [B].
4. Using the front handles and rear handles, lift the machine and hold it over the
paper tray unit [C].
5. Slowly lower the main machine onto the paper tray unit with the pegs [D]
aligned with the peg holes on the bottom of the machine.
NOTE: Do not hold the scanner unit.
6. Re-install the middle front cover [A].
7. Attach the lock washer [E] to the short knob screw [F]. Then, secure the paper
tray unit to the machine (! x1, spring washer).
8. Open the right cover of the paper tray unit [G].
9. Secure the joint bracket [H] (! x 1).
10. Remove the connector cover [I] of the main machine (! x1).
11. Connect the paper tray unit harness [J] to the main machine and re-attach
the connector cover.
A682I113.WMF
A682I517.WMF
[A]
[B]
[F]
[C]
[D]
[E]
[D]
[G]
[H]
[I]
[J]