1-BIN TRAY UNIT INSTALLATION 26 January, 2001
1-24
2. Unpack the 1-bin tray unit and remove the tapes.
3. Remove the front bracket [A] (! x1) and rear bracket [B] (! x1) from the top of
the paper exit cover [C] (! x 1 each).
4. Remove the paper exit cover [C] (! x 4).
5. Cut away two covers [D] from the base cover [E].
6. Trim the edges so they are smooth.
7. Install the base cover [E] (! x 3: stepped screw).
8. Set the 1-bin tray unit [F] on the base cover and slide it onto the heads of the
stepped screws.
B376I201.WMF
B376I102.WMF
[A]
[B]
[C]
[D]
[E]
[F]
To Next Page
Loading...
