PM TABLE 26 January, 2001
2-2
B003/B004B006/B007 EM 150K 300K 450K NOTE
DEVELOPMENT UNIT
Development Drive
Gears
III
Development Filter R R R
Developer I R I
Entrance Seal I I I
Side Seal I I I
Development Roller C C C Dry cloth
PAPER FEED
Registration Roller CCCCWater or alcohol.
Paper Feed Roller I R R R
Separation Roller I R R R
Pick-up Roller I R R R
Paper Feed Roller (By-
pass feed table)
I RRR
Separation Roller (By-
pass feed table)
I RRR
Pick-up Roller
(By-pass feed table)
I RRR
Check counter value for
each (SP7-204). If ≥ 150 K,
replace roller. After replacing
the roller, do SP7-816 to
reset counter.
Paper Feed Guides C C C Water or alcohol.
Relay Rollers C C C Water or alcohol.
Bottom Plate Pad C C C Water or alcohol.
Bottom Plate Pad (By-
pass feed)
CCC
Water or alcohol.
Registration Sensor C C C Blower brush
Paper Feed Roller Gear
LLL
Silicone Grease G-501. See
note below.
1
DUPLEX UNIT
Upper Transport Roller C C C Water or alcohol.
Lower Transport Roller C C C Water or alcohol.
TRANSFER BELT UNIT
Transfer Belt CRRRDry cloth
Transfer Belt Cleaning
Blade
RRR
Transfer Belt Rollers C C C Dry cloth
Entrance Seal C C C Dry cloth
Transfer Entrance
Guide
CCCC
Dry cloth
Used Toner Tank I C C C Empty the tank.
To Next Page
Loading...
