System Service Mode
D115/D116 3-10 SM Appendix
2994*
ID Detect Temp
[30 to 90 / 30 / 1°C/step]
2994 1
Adjusts the temperature threshold. The ID sensor signal is not referenced
when the fusing temperature is at the specified level or higher while the
copier is recovering or starting up.
2996*
T Roller Cleaning
[0 = No / 1 = Yes]
2996 1
Cleans or does not clean the transfer roller before each job. Select "1" if the
backside of the paper becomes unclean when output. Note that the copier
takes a longer time to output the first copy when you select "1". If you select
"0", the transfer roller is never cleaned.
2998*
Main Mag- print
[–0.5 to +0.5 / 0.0 / 0.1%/step]
2998 1
Adjusts the magnification (
"Adjusting Copy Image Area" in the section
"Replacement and Adjustment"). The specification is 100 ±1.0%.
To Next Page
Loading...
