System Service Mode
D115/D116 3-44 SM Appendix
008 RCG Connect T/O
Specifies the connect timeout interval when calling
the RCG.
[1 to 90 / 10 / 1 second/step]
009 RCG Write Timeout
Specifies the write timeout interval when calling the
RCG.
[1 to 100 / 60 / 1 second/step]
010 RCG Read Timeout
Specifies the read timeout interval when calling the
RCG.
[1 to 100 / 60 / 1 second/step]
011 Port 80
Enables/disables access via port 80 to the SOAP
method.
[0 or 1 / 0 / – ]
0: Disabled, 1: Enabled
013 RFU Timing
Selects the timing for the remote firmware updating.
[0 or 1 / 0 / – ]
0: Any status of a target machine
1: Sleep or panel off mode only
022
Install Status
This SP displays the RCG device installation status.
0: RCG device not registered
1: RCG device registered
2: Device registered
023
Connect Mode (N/M)
This SP displays and selects the embedded RCG connection method.
0: Internet connection
1: Dial-up connection
061
NotiTime ExpTime DFU
Proximity of the expiration of the certification.
To Next Page
Loading...
