Bit Switches
D115/D116 5-14 SM Appendix
System Switch 0A [SP No. 1-101-011]
No FUNCTION COMMENTS
0-3
Not used
Do not change these settings.
4 Dialing on the ten-key pad
when the external
telephone is off-hook
0: Disabled 1: Enabled
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting
when the external telephone is not by the
machine, or if a wireless telephone is connected
as an external telephone.
1: The user can dial on the machine’s ten-key pad
when the handset is off-hook.
5 On hook dial
0: Disabled 1: Enabled
0: On hook dial is disabled.
6-7
Not used
Do not change the factory settings.
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E [SP No. 1-101-015]
No FUNCTION COMMENTS
0-1
Not used
Do not change the settings.
2
Not used
This machine does not have the capture function.
3
Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the
same)
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
Note that manual tx and rx are not possible with
To Next Page
Loading...
