Bit Switches
D115/D116 5-16 SM Appendix
System Switch 10 [SP No. 1-101-017]
No FUNCTION COMMENTS
0-7
Threshold memory level for
parallel memory transmission
Threshold = N x 128 KB + 256 KB
N can be between 00 - FF(H)
Default setting: 02(H) = 512 KB
System Switch 11 [SP No. 1-101-018]
No FUNCTION COMMENTS
0
TTI printing position
0: Superimposed on the page
data
1: Printed before the data
leading edge
Change this bit to 1 if the TTI overprints
information that the customer considers to be
important (G3 transmissions).
1
Not used
Japan Only
2-7
Not used
Do not change the factory settings.
System Switch 12 [SP No. 1-101-019]
No FUNCTION COMMENTS
0-7
TTI printing position in the
main scan direction
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI from the left edge of the paper. If the TTI is
moved too far to the right, it may overwrite the file
number which is on the top right of the page. On
an A4 page, if the TTI is moved over by more than
50 mm, it may overwrite the page number.
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
To Next Page
Loading...
