Ricoh B089 - Service Program Mode Tables

SERVICE PROGRAM MODE
B089/B093 4-6 SM
4.2.2 SERVICE PROGRAM MODE TABLES
Service Table Key
Notation What it means
[range / default /
step]
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, the setting is reset to +3.0 after an
NVRAM reset, and the value can be changed in 0.1 mm steps with
each key press.
italics Comments added for reference.
*
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
1111
An SP number set in bold-italic denotes a “Special Service
Program” mode setting that appears only after entering the SP
mode by pressing  and Copy SP together. (! 4.2.1)
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
(S) Sideways feed direction
(L) Lengthwise feed direction