Ricoh B089 - Correcting Trapezoid Images

CORRECTING THE IMAGES
B089/B093 6-50 SM
6.11.2 CORRECTING TRAPEZOID IMAGES
Procedure 1: Minor Adjustment of the Fusing Unit Height (front-to-rear)
1. Print out the SP2-902-003 Trimming Pattern (value: 10).
2. If the image is a Pattern A trapezoid:
1) Remove and reinsert the Fusing Unit.
2) Tighten the left fixing screw while pushing up on the unit’s left side
(until it
stops).
3. If the image is a Pattern B trapezoid, do the same for the unit’s right side
.
4. If the image is still printed out as a trapezoid, perform Procedure 2.