Ricoh B089 - Paper Size Sensor Board

PAPER SIZE SENSOR BOARD
A899/B415 14-6 SM
3.2 PAPER SIZE SENSOR BOARD
1. Remove the rear cover [A] (2 screws).
2. Remove the by-pass tray [B] (1 connector, 2 release levers [C]).
3. Remove the lever [D] (1 snap ring, 1 pin).
4. While pushing the release lever [E], remove the paper tray [F].
5. Remove the by-pass width sensor [G].
NOTE: When installing the by-pass width sensor [G], move the side fence inward
all the way so that the seal on the side face gear faces the surface with the
seal [H] on the by-pass width sensor.
B415R502.WMF
B415R503.WMF
[B]
[A]
[C]
[G]
[H]
[F]
[E]
[D]