SERVICE PROGRAM MODE
B089/B093 4-104 SM
Finisher Input Check (SP6117)
1. Enter the SP mode and select SP6117.
2. Enter the number (1 – 4) for the item that you want to check. A small box will be
displayed on the SP mode screen with a series of 0’s and 1’s.
The meaning of the display is as follows.
0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
3. Check the status of each item against the corresponding bit numbers listed in
the table below.
For 1000-sheet Finisher
Reading
Number Bit Description
0 1
7 Stack Feed-out Belt HP Sensor Activated Deactivated
6 Not Used
5 Jogger Fence HP Sensor Activated Deactivated
4 Stapler HP Sensor Activated Deactivated
3 Stapler Tray Entrance Sensor Activated Deactivated
2 Not Used
1 Lower Tray Exit Sensor Activated Deactivated
1
0 Entrance Sensor Activated Deactivated
7 Not Used
6 Not Used
5 Stapler Ready Signal Activated Deactivated
4 Not Used
3 Not Used
2 Staple Sensor Activated Deactivated
1 Staple Hammer HP Sensor Activated Deactivated
2
0 Stapler Tray Paper Sensor Activated Deactivated
7 Not Used
6 Lower Tray Lower Limit Sensor Activated Deactivated
5 Not used
4 Stack Height Sensor Activated Deactivated
3 Not Used
2 Not Used
1 Shift HP Sensor Activated Deactivated
3
0 Exit Guide HP Sensor Activated Deactivated
To Next Page
Loading...
