Ricoh B089 - Sp1 Xxx: Feed

SERVICE PROGRAM MODE
SM 4-7 B089/B093
Service
Tables
SP1XXX: Feed
1001* Leading Edge Registration [+9.0 ~ –9.0 / +0.0 / 0.1 mm/step]
1001 1 Paper Tray Feed
1001 2 By-pass Feed
1001 3 Duplex, Side2
Adjusts the printing leading edge registration from
each paper feed station using the Trimming Area
Pattern (SP4417, No.15).
Use the  key to toggle between + and – before
entering the value.
The specification is 3 ± 2 mm.
See “Replacement and Adjustment - Copy
Adjustment” for details.
1002* Side-to-Side Registration [+9.0 ~ –9.0 / +0.0 / 0.1 mm/step]
1002 1 Tray 1
1002 2 Tray 2
1002 3 Tray 3 (Optional PFU Tray 1, or
LCT)
1002 4 Tray 4 (Optional PFU Tray 2)
1002 5 By-pass
1002 6 Duplex Side 2
Adjusts the printing side-to-side registration
from each paper feed station using the
Trimming Area Pattern (SP4417, No.15).
Use the  key to toggle between + and –
before entering the value. The specification is
2
± 1.5 mm. See “Replacement and
Adjustment - Copy Adjustment” for details.
1003* Paper Feed Timing
1003 1 Tray 1
1003 2 Tray 2/3/4 By-pass
Adjusts the paper feed clutch timing at registration.
The paper feed clutch timing determines the amount
of paper buckle at registration. (A larger setting leads
to more buckling.)
[0 ~ 10 / 5 / 1 mm/step]
1003 3 Duplex Side 2 [0 ~ 20 / 6 / 1 mm/step]
1007 By-pass Paper Size Display Displays the by-pass paper width sensor output.
Fusing Idling [0 = Off / 1 = On / 2 = Off plus machine
temperature check]
1103
Switches fusing idling on/off.
Switch on if fusing on the 1st and 2nd copies is incomplete (this may occur if the
room is cold.)