Ricoh B089 - Paper End Sensor Replacement; Vertical Transport Sensor Replacement

PAPER END SENSOR REPLACEMENT
A860/B390 8-20 SM
3.8 PAPER END SENSOR REPLACEMENT
1. Remove the paper tray.
2. Remove the paper end sensor bracket [A] (1 screw and 1 connector).
3. Replace the paper end sensor [B].
NOTE: After replacing the sensor, pull the sensor cable towards the right side of
the frame [C] so that it does not touch the paper in the tray.
3.9 VERTICAL TRANSPORT SENSOR REPLACEMENT
1. Open the right door [A].
2. Remove the right guide plate [B] (2 screws).
3. Remove the vertical transport sensor bracket [C] (1 screw and 1 connector).
4. Replace the vertical transport sensor [D].
B390R106.WMF
B390R105.WMF
[A]
[B]
[C]
[D]
[A]
[C]
[B]