SERVICE PROGRAM MODE
SM 4-57 B089/B093
Service
Tables
SP6XXX: Peripherals
6006* DF Adjustment
These settings adjust the registration and other settings for the ADF mode. Use
the key to toggle between + and - before entering a value. For more details,
see “Replacement and Adjustment - Copy Adjustment” for details.
6006 1 Side-to-Side
(For Simplex)
6006 2 Leading Edge
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
6006 3 Trailing Edge Erase Adjusts the trailing edge erase margin.
.[–5.0 ~ +5.0 / 1.0 / 0.1 mm/step]
6006 4 Side-to-Side/Rear
(For Duplex)
Adjusts the side-to-side registration on the rear side of
the original.
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
6006 5 Sub Scan
Magnification
Adjusts the sub scan magnification.
[–5.0 ~ +5.0 / 0.0 / 0.1 % step]
6006 6 Skew Correction Selects whether skew correction is done.
0 = Off, 1 = On
6006 7 Original Buckle
Adjustment
Adjusts the amount of original buckle at the ARDF
registration roller when the ARDF feeds the back side of
the original.
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
ADF Input Check 6007
Displays the signals received from sensors and switches of the ARDF.( ! 4.2.4)
ADF Output Check 6008
Switches on each electrical component (ARDF motor, solenoid, etc.) of the ARDF
for testing. (! 4.2.5)
Press to switch on or to switch off.
ADF Free Run 6009
Performs an ARDF free run in duplex mode. Press to start.
1: To Start, 0: To cancel
This is a general free run controlled from the copier. For more detailed free run
modes, see the ARDF manual.
Stamp Position Adjustment 6010*
Adjusts the stamp position in the sub-scan direction in fax mode.
[–5.0 ~ +5.0 / 0 / 1 mm/step]
ADF Original Size Detection 6016*
Selects whether the machine determines that the original is A4/LT, or 8K/16K
when the APS sensor in the ADF does not detect the original size.
8K/16K is not available for 115V machines.
[0 = Normal (LT for USA models, A4 for Europe/Asia models)
1 = Reversed [A4 for USA models, LT for Europe/Asia models]
2 = 8K/16K]
To Next Page
Loading...
