SERVICE PROGRAM MODE
B089/B093 4-58 SM
Staple Position Adjustment [–3.5~+3.5 / 0.0 / 0.5 mm step]6105*
Adjusts the staple position in the main scan direction when using the two-tray
finisher.
Press
to toggle
±
. A larger value shifts the staple toward the edge of the
paper.
Finisher Input Check 6117
Displays the signals received from sensors and switches in the finisher. ( !
4.2.4)
Finisher Output Check 6118
Switches on each electrical component of the finisher for testing. (! 4.2.5)
Press to switch on or to switch off.
ADF APS Data Display 6901
Displays the status of the original size sensors in the ADF. (! 4.2.10)
ADF Shading Interval Time 6910*
Adjusts the interval for shading processing in DF mode.
Light and heat may affect the scanner response. If copy quality indicates that
white level is drifting during a DF copy job, reduce this setting.
[0 ~ 120 / 20s / 1s/step]
6920 DF Check
6920 1 DF GATE
DFU
0 = Gate, 1 = Asart
6920 2 DF TXD Break
DFU
0 = Off, 1 = On
6920 3 Serial Communication
DFU
0 = NG, 1 = OK
6920 4 Original Set
DFU
0 = Off, 1 = On
6920 5 Serial Check
DFU
6925 Bridge/Duplex/By-Pass/Loop Back DFU
6925 1 Practice
DFU
6925 2 Result
DFU
To Next Page
Loading...
