COPY SP SERVICE TABLES
SM 13 B692/B694
B692/B694
Data
Overwrite
Security Unit
5. SERVICE TABLES
Service Table Key
Notation What it means
[range / default / step]
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
*
Value stored in NVRAM. After a RAM reset, this default value
(factory setting) is restored.
1111
An SP number set in bold-italics denotes a “Special Service
Program” mode setting. To display the SSPs:
1. Enter the SP mode.
2. On the touch panel, press “Copy SP” and together.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only
The feature or item is for Japan only. Do not change this
value.
LEF Long Edge Feed
SEF Short Edge Feed
(!6.2 Image Processing)
Refer to “6.2 Image Processing” in “6. Details”.
Due to fundamental changes in how image processing
adjustment is done with Group 4 SP codes, more details are
provided in Section 6.
To Next Page
Loading...
