BEFORE YOU BEGIN
B692/B694 2 SM
1.2 BEFORE YOU BEGIN
1.2.1 SEAL CHECK AND REMOVAL
CAUTION
Before you start the installation, you must check the box seals to confirm
that they have not been removed since the items were sealed in the box at
the factory.
1. Check the box seals [A] on each corner of the box.
• Confirm that a tape is attached to each corner.
• The surfaces of the tapes should be blank. If you see “VOID” on the tapes
STOP, do not install the components, contact your superviser.
2. If the surfaces of the tapes are unmarked, remove from the corners of the box.
3. As you remove each seal, the “VOID” marks [B] appear. This prevents the tape
from being reattached to the box.
4. Make sure that you have the correct security module for the machine. The
machine model requires either the DIMM type or the SD Card type.
Model Security Module Required
B135/B138 e/f DOS Unit Type A (DIMM)
B089/B093 DOS Unit Type A (DIMM)
B147/B149 DOS Unit Type B (SD Card)
B692I901.WMF
B692I903.WMF
[B]
[A]
To Next Page
Loading...
