NCU PARAMETERS
SM 3-55 B576
Fax Option
B576
3.3 NCU PARAMETERS
The following tables give the RAM addresses and the parameter calculation units
that the machine uses for ringing signal detection and automatic dialing. The
factory settings for each country are also given. Most of these must be changed by
RAM read/write (SP2-101), but some can be changed using NCU Parameter
programming (SP2-103 and 104); if SP2-103 and 104 can be used, this will be
indicated in the Remarks column. The RAM is programmed in hex code unless
(BCD) is included in the Unit column.
NOTE: The following addresses describe settings for the standard NCU.
Change the fourth digit from “5” to “6” (e.g. 680500 to 680600) for the
settings for the optional G3 interface unit.
To Next Page
Loading...
