SERVICE PROGRAM MODE
B089/B093 4-106 SM
4.2.5 OUTPUT CHECK
NOTE: Motors keep turning in this mode regardless of upper or lower limit sensor
signals. To prevent mechanical or electrical damage, do not keep an
electrical component on for a long time.
Main Machine Output Check (SP5804)
1. Open SP mode 5804.
2. Select the SP number that corresponds to the component you wish to check.
(Refer to the table on the next page.)
3. Press On then press Off to test the selected item.
NOTE: You cannot exit and close this display until you press off to switch off
the output check currently executing. Do not keep an electrical
component switched on for a long time.
Output Check Table
NOTE: Pull out the tray before performing the output checks 25, 26, 29, and 30.
Number On Screen Service Manual Part Name
1 Main Motor (Fwd) Main motor (forward)
2 Main Motor (Rev) Main motor (Reverse) Do not use
3 Registration CL Registration clutch
4 Development CL Not used
5 Toner Bottle Motor Toner supply motor
6 Exhaust Fan Motor (High Speed) Exhaust fan (High Speed)
7 Exhaust Fan Motor (Low Speed) Exhaust fan (Low Speed)
8 By-pass Feed CL By-pass feed clutch
9 1st Paper Feed CL Upper paper feed clutch
10 2nd Paper Feed CL Lower paper feed clutch
11 1st Paper Tray Up Upper paper lift motor (Up)
12 1st Paper Tray Down Upper paper lift motor (Down)
13 2nd Paper Tray Up Lower paper lift motor (Up)
14 2nd Paper Tray Down Lower paper lift motor (Down)
15 Paper Transport CL Upper relay clutch
16 Paper Transport CL2 Lower relay clutch
17 Fuser Drive Cancel SOL Fusing drive release solenoid
B089S904.WMF
To Next Page
Loading...
