CORRECTING THE IMAGES
SM 6-51 B089/B093
Replacement
Adjustment
Procedure 2: Minor Adjustment of the Fusing Unit Position (front-to-rear)
1. Remove the Fusing Unit, then add a washer (t = 0.5 to 1.6) to the front fixing
screw. Note: This will increase the distance from the mainframe stay.
2. Check the image.
Still NG OK
Adjustment Complete.
3. Add more washers (t = 0.5 to 1.6, as above).
Note: Too many washers can cause wrinkling in the paper.
Still NG OK
Adjustment Complete.
4. Remove the Fusing Unit and all the washers added in Steps 1 and 2 above.
Then, add washer(s) in the same way for the rear side.
Recommended Washers:
t = 0.5 07080040Z
t = 0.8 07080050Z
To Next Page
Loading...
