SERVICE PROGRAM MODE
B089/B093 4-22 SM
2907* Line Width Correction
Adjusts the line width for the copy mode. The default setting disables this function.
A number smaller than the default makes lines thinner, a number larger than the
default makes lines thicker.
2907 1 Text Mode [0 ~ 10 / 5 / 1 step]
2907 2 Photo Mode [0 ~ 10 / 6 / 1 step]
2907 3 Text/Photo Mode
2907 4 Pale Mode
2907 5 Generation Mode
[0 ~ 10 / 5 / 1 step]
Forced Toner Supply 2908
Forces the toner bottle to supply toner to the toner supply unit.
Press Execute on the touch panel to start.
During this process, the machine supplies toner until the toner concentration in the
development unit reaches a standard level. However, if the toner concentration
does not reach a standard level, the machine supplies toner for 2 minutes
maximum.
2909* Main Scan Magnification [-0.5 ~ 0.5 / 0.0 / 0.1%/step]
2909 1 Copy (Short Edge Feed)
Adjusts the main scan magnification in copy mode when the machine feeds the
paper in the short edge feed orientation.
2909 2 Printer (Short Edge Feed)
Adjusts the main scan magnification in printer mode when the machine feeds the
paper in the short edge feed orientation.
2909 3 Copy –(Long Edge Feed)
Adjusts the main scan magnification in copy mode when the machine feeds the
paper in the long edge feed orientation.
2909 4 Printer (Long Edge Feed)
Adjusts the main scan magnification in printer mode when the machine feeds the
paper in the long edge feed orientation.
Margin Adjustment for By-pass 2910*
Adjusts the blank margin at the trailing edge of paper fed from the by-pass table.
[-9.0 ~ +9.0 / 0.1 mm / 1mm/step]
ID Adjustment for Test Pattern [0 ~ 15 / 15 / 1/step]2913*
Adjusts the image density level for black pixels on test pattern printouts (patterns
are made with SP2902)
This SP affects all test patterns except for the grayscale test patterns.
To Next Page
Loading...
