SERVICE PROGRAM MODE
B089/B093 4-26 SM
2995* ID Sensor Detection Interval
2995 1 Warming-up
If the machine starts warming-up after this time has passed since entering energy
saver mode or auto off mode, the machine makes an ID sensor pattern.
If this value is greater, there is a greater chance that background will become
dirty.
[0 ~ 999 / 30 / 1 minute/step]
2995 2 Number of Page
The machine makes an ID sensor pattern after the specified number of prints has
been made. 0 = this feature is disabled.
[0 ~ 999 / 0 / 1 page/step]
Transfer Roller Cleaning 2996*
Selects whether the transfer roller is cleaned before each copy job.
Set this to ‘1’ when dirty background appears on the reverse side of the first page
of a copy job. However, the first copy time will be longer.
If this SP is at 0, the transfer roller is never cleaned.
See ‘Detailed Section Descriptions – Transfer Roller Cleaning” for more details.
[0 = No / 1 = Yes]
2997* Standard Vt (Factory Only)
DFU
2998* PCU Reverse Rotation Time
2998 1 Wait Time
Adjusts the waiting time for starting to rotate the drum in reverse after the end of
each job.
The wait time calculation formula is as follows.
This value x 30 ms. 0: Reverses immediately after the end of the job (no waiting)
[0 ~ 99 / 10 / 1/step]
2998 2 Reverse Time
Adjusts the drum reverse rotation time.
The reverse rotation time calculation formula is as follows.
This value x 30 ms. 0: No reverse at end of job
[0 ~ 99 / 1 / 1/step]
Toner Control Data Display 2999*
Displays the toner density control data on the debug monitor. DFU
[0 = No / 1 = Yes]
To Next Page
Loading...
