SERVICE PROGRAM MODE
B089/B093 4-28 SM
4015* White Plate Scanning
4015 1 Start Position
Adjusts the scanning start position on the white plate for auto shading.
The default is 10.5 mm from the leading edge. The setting specifies how far
scanning starts from the default position.
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
4015 2 Scanning Area
Adjusts the width of the area on the white plate (in the sub scan direction) that is
scanned for auto shading.
The default is 4.76 mm. The current setting specifies the difference from this
default.
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
APS Data Display 4301
Displays the status of the APS sensors and platen/DF cover sensor (! 4.2.9).
APS Small Size Original 4303*
Selects whether the copier determines that the original is A5 size when the APS
sensor cannot detect the size.
If “A5 lengthwise” is selected, paper sizes that cannot be detected by the APS
sensors are regarded as A5 lengthwise. If “Not detected” is selected, “Cannot
detect original size” will be displayed.
[0 = No (Not detected) / 1 = Yes (A5 lengthways)]
Original Size Detection 4305*
Selects whether the machine determines that the original is A4/LT, or 8K/16K.
8K/16K is not available for USA models.
[0 = Normal (LT for USA models, A4 for Europe/Asia models)
1 = Reversed [A4 for USA models, LT for Europe/Asia models]
2 = 8K/16K]
To Next Page
Loading...
