Ricoh B089 - Page 445

Paper Tray
Unit
A860/B390
PAPER HEIGHT DETECTION
SM 8-11 A860/B390
The amount of remaining paper depends on SP modes 1-908-6, 7, 15, and 16. The
amount of forward rotation depends on SP1-908-4, 5, 13, and 14. Note that there
are two paper size thresholds for each tray: small and middle (this is the same as
for the paper lift mechanism described earlier). Some models only use the small
threshold. The paper size thresholds depend on SP1-908-8, 9, 17, and 18.
The following table summarizes how these SP modes work.
No Middle Size Programmed
With Middle Size
Programmed
Paper width:
Tray 1: More than 1-908-8
Tray 2: More than 1-908-17
(Default: Wider than HLT)
Amount of forward rotation:
None
Paper width:
Tray 1: More than 1-908-9
Tray 2: More than 1-908-18
Amount of forward rotation:
None
Paper width:
Tray 1: 1-908-8 or less
Tray 2: 1-908-17 or less
(Default: HLT or narrower)
Amount of remaining paper:
Tray 1: 1-908-6
Tray 2: 1-908-15
(Default: When near-end is
detected)
Amount of forward rotation:
Tray 1: 1-908-4
Tray 2: 1-908-13
(Default: 300 ms)
Paper width:
Tray 1: More than 1-908-8, up
to and including 1-908-9
Tray 2: More than 1-908-17, up
to and including 1-908-18
Amount of remaining paper:
Tray 1: 1-908-7
Tray 2: 1-908-16
Amount of forward rotation:
Tray 1: 1-908-5
Tray 2: 1-908-14
Paper width:
Tray 1: 1-908-8 or less
Tray 2: 1-908-17 or less
Amount of remaining paper:
Tray 1: 1-908-6
Tray 2: 1-908-15
Amount of forward rotation:
Tray 1: 1-908-4
Tray 2: 1-908-13