500-Sheet
Finisher
G302/B442
DETAILED SECTION DESCRIPTIONS
SM 18-17 G302/B442
Shift sorting mode
At the start of the job, and for odd numbered sets of copies, the mechanism is the
same as the straight feed out mode. However, even numbered sets are fed back to
the jogger tray, which shifts the sets to one side before feeding them out.
This section describes what happens for even-numbered sets (sets 2, 4, 6 etc) of
the job.
A short time after the entrance sensor [A] detects the first page of the set, the
paper exit unit solenoid turns on to restart the rotation of the paper exit unit gear,
raising the paper exit unit to the standby position. It stays there until after the last
page of the set.
The paper cannot feed out, so it drops into the jogger tray [B]. The paddle roller
solenoid [C] turns on and the paddle roller [D] feeds the paper to the reverse roller
[E]. The reverse roller feeds the paper to the end fence [F] of the jogger tray.
B442D113.WMF
B442D111.WMF
[A]
[E]
[F]
[B]
[D]
[C]
To Next Page
Loading...
