500-Sheet
Finisher
G302/B442
DETAILED SECTION DESCRIPTIONS
SM 18-19 G302/B442
Stapling mode
The stapler is attached to the jogger tray, so all sets go to the jogger tray.
After all pages of a set have entered the jogger tray and been shifted across, the
paper exit link [A] pulls the paper exit unit [B] down until knob [C] on the exit unit
pushes the link lever [D] for the exit unit switch [E]. This turns on the exit unit
switch. When this switch is on, dc is supplied to the stapler unit [F] and the main
motor is turned off.
The exit unit switch is activated when the exit unit is pulled part-way down. After
stapling the set of prints, the paper exit unit is pulled down again until the unit
comes in contact with the paper exit roller [G], and the stapled set is fed out.
B442D112.WMF
B442D114.WMF
B442D106.WMF
[B]
[C]
[E]
[F]
[D]
[A]
[G]
[B]
To Next Page
Loading...
