BIT SWITCHES
B576 3-16 SM
System Switch 11 SP No. 1-101-018
No FUNCTION COMMENTS
0
TTI printing position
0: Superimposed on the page
data
1: Printed before the data
leading edge
Change this bit to 1 if the TTI overprints information
that the customer considers to be important (G3
transmissions).
1
TSI (G3) printing position
0: Superimposed on the page
data
1: Printed before the data
leading edge
Change this bit to 1 if the TSI (G3) overprints
information that the customer considers to be
important.
2-7 Not used Do not change the factory setting.
System Switch 12 SP No. 1-101-019
No FUNCTION COMMENTS
0 to 7
TTI printing position in the
main scan direction
TTI/CIL: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI and CIL from the left edge of the paper. If
the TTI is moved too far to the right, it may overwrite
the file number which is on the top right of the page.
System Switch 13 - Not used (do not change the settings)
System Switch 14 - Not used (do not change the settings)
System Switch 15 SP No. 1-101-022
No FUNCTION COMMENTS
0 Not used Do not change the setting.
1
Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
2-7 Not used Do not change the settings.
To Next Page
Loading...
