BIT SWITCHES
B576 3-18 SM
System Switch 1A SP No. 1-101-026
No FUNCTION COMMENTS
0
to
7
LS RX memory remaining
refresh value setting
Sets a value of 4K.
If the amount of memory remaining falls below 4K,
documents received in memory are printed to create
more space in memory.
Initial value: 0x80 (512K)
00-FF (0-1020 KB: Hex)
System Switch 1B - Not used (do not change the settings)
System Switch 1C - Not used (do not change the settings)
System Switch 1D SP No. 1-101-030
No FUNCTION COMMENTS
0
RTI/CSI display
0: Disabled
1: Enabled
1: RTI/CSI is displayed on the top line of the LCD
panel during communication.
1-7 Not used Do not change the settings.
System Switch 1E SP No. 1-101-031
No FUNCTION COMMENTS
0
Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the
report (e.g., no paper).
0: If the buffer memory of the communication records
for the Journal has become full, fax communications
will become impossible, to prevent overwriting the
communication records before the machine prints
them out.
1: If the buffer memory of the communication records
for the Journal is full, fax communications are still
possible. But the machine will overwrite the oldest
communication records.
Cross Reference
! Automatic Journal output - User switch 03 bit 7
! Number of communication records for the
Journal:
200 records (standard)
1000 records (with the Function Upgrade unit
installed)
1
Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
To Next Page
Loading...
