Ricoh J-P2 - Waste Oil Bottle

17 January, 2003 FUSING
3-41
Replacement
Adjustment
3.9.13 WASTE OIL BOTTLE
1. Open the front cover [A].
2. Release the hook [B].
3. Waste oil bottle [C]
4. Close the bottle with the lid [D].
5. Dispose of the bottle (with waste oil in it) in accordance with your local
regulations.
NOTE: 1) The messages, “Waste Oil Bottle is Almost Full” and “Waste Oil Bottle is
Full”, are cleared when the front cover is closed. You do not need to turn
the main switch off and on.
2) The message, “Reset Waste Oil Bottle correctly”, indicates that the
bottle is not in position. Check that the bottle is correctly reinstalled if
this message is displayed.
G080R759.WMF
[C]
[B]
[D]
[A]