Ricoh J-P2 - Controller and Bcu

ELECTRICAL COMPONENTS 17 January, 2003
3-44
3.10.3 CONTROLLER AND BCU
NOTE: 1) Before replacing the BCU or controller, print out the SMC reports (“SP
Mode Data” and “Logging Data”).
2) After replacing the BCU or controller, remove the NVRAM on the old
board and install it on the new board.
1. Controller [A] (! x 2)
2. Option bracket [B] (! x 2)
3. Rear cover [C] (☛3.3)
4. Cover bracket [D] (! x 3)
5. Inner bracket [E] (! x 2)
G080R938.WMF
G080R939.WMF
[D]
[E]
[A]
[C]
[B]