Ricoh J-P2 - Paper Size Detection

To Next Page

To Previous Page

17 January, 2003 PAPER FEED

6-53

Detailed

Descriptions

6.6.4 PAPER SIZE DETECTION – TRAYS 1 & 2

For tray 1, there is no size switch. The paper size is fixed at either A4 or LT; this

can be changed with SP1-902-1.

For tray 2, four paper size switches, working in combination, detect the paper size

as shown in the table below. The actuators are on the side plate [A]. The side plate

is moved by the end plate [B] through a cam [C].

1: Pushed

Models Switch Location

North America Europe/Asia 1 [D] 2 [E] 3 [F] 4 [G]

11" x 17" SEF 11" x 17" SEF 0 1 0 0

A3 SEF A3 SEF 1 0 1 0

81/2" x 14" SEF

B4 SEF

1 1 0 1

81/2" x 11" SEF

A4 SEF

0 1 1 0

11" x 81/2" LEF

1 0 1 1

A4 LEF A4 LEF 0 1 0 1

B5 LEF B5 LEF 0 0 1 0

A5 LEF A5 LEF 0 0 0 1

NOTE:

: The machine detects either 81/2" x 14" SEF or B4 SEF, depending on the setting of SP 1-902-2

: The machine detects either 81/2" x 11" SEF or A4 SEF, depending on the setting of SP 1-902-3

: The machine detects either 11" x 81/2" LEF or B5 SEF, depending on the setting of SP 1-902-4

The machine disables paper feed from a tray if the paper size cannot be detected

(if the paper size actuator is broken or no tray is installed).

G080D962.WMF

[A]

[B]

[C]

[D]

[E] [F]

[G]

Ricoh J-P2 - Paper Size Detection - Trays 1 & 2