17 January, 2003 FIRMWARE UPDATE – CF CONFIGURATION
5-99
Service
Tables
5.8 FIRMWARE UPDATE – CF CONFIGURATION
The features in this section, “Firmware Update – CF Configuration,” are valid when
the optional CF expander is installed.
5.8.1 TYPE OF FIRMWARE
There are 11 types of firmware as shown below.
Type of firmware Function
Location of
firmware
Message displayed
* Engine - Main Printer engine control BCU Flash ROM Engine (1)
* Engine - Music Line position adjustment BCU MUSIC CPU Music (1)
* Engine - DSP Line position adjustment BCU DSP CPU DSP (1)
• System
• Copier Application
• Netfile Application
3 different firmware (system
and Copier and Netfile
applications) is combined.
DIMM 1 Onboard Sys (2)
Printer Application Feature application DIMM 1 Onboard Printer (1)
Scanner Application Feature application DIMM 2 Onboard Scn (1)
Fax Application Feature application DIMM 2 Opt DIMM Fax (1)
* NIB Network Interface DIMM 2 Network Support (1)
Scanner IPU Scanner control IPU Flash ROM Scanner IPU (1)
Operation Panel Panel control Operation Panel Ope Panel. XX (1)
Fax FCU Fax control FCU Jupi FCU (XXX)-1 (1)
Language
(16 languages)
Language firmware
Two languages can be
selected from 16
languages.
Operation Panel Download Language
* The firmware with an asterisk mark is used in both the printer (G080) version and
CF (G080+G367) version. Other firmware is unique for the CF version. (For
example, if you insert the IC card containing controller firmware for the printer
version, “Download Error SC999” is displayed.
Refer to “5.4.3 Firmware Upgrade” for the procedure.
5.8.2 ERROR RECOVERY
If an error occurs during the firmware update, “NG!” or “ERR” is displayed. In this
case, turn the main switch off and retry the firmware update after reinserting the IC
card using the procedure described in section 5.6.3.
To Next Page
Loading...
